Short Answer
Find where the air is getting in first, then match the fix to the gap. Cracks between the trim and the wall or siding get caulk. Gaps where the sashes meet the frame get weatherstripping, and a loose sash lock gets tightened. For old windows you can’t fix this winter, rope caulk or a shrink-film kit gets you through to spring. Most of it is an afternoon of work and a few tubes of caulk.
This box contains affiliate links. As an Amazon Associate I earn from qualifying purchases. See the affiliate note at the bottom of this post.
🛒 Helpful Picks
The caulk is the one I use on the job. The rest are well-reviewed options to compare, not specific products I’m vouching for.
- The caulk I use for gaps around trim
- Rope caulk you press into gaps for the winter and peel out in spring
- Window shrink-film kits for old single-pane or loose windows
- V-strip weatherstripping for the sides of double-hung sashes
Drafty windows are a classic winter problem in older Northeast Ohio homes, especially ones with original wood windows. The good news is that most drafts come from a few predictable spots, and you can fix most of them without replacing anything. The Department of Energy says heat gain and loss through windows accounts for 25% to 30% of the energy a home uses for heating and cooling, so it’s worth an afternoon.
Step 1: Find Where the Air Is Coming In
Don’t caulk everything and hope. Pick a cold, windy day, close every window and door, turn off the furnace fan and bath fans, and check each window:
- Feel with the back of your hand along the edges of each sash, the meeting rail in the middle, and where the trim meets the wall.
- Use a stick of incense or a candle (careful near curtains and blinds). Where the smoke wavers or the flame flickers, there’s a leak.
- Look for daylight around the sash and for cracked or missing caulk outside.
I go through the whole-house version of this in how to check your home for drafts. For windows, most leaks land in one of three places: the trim, the sash, or the glass itself.
Step 2: Tighten What’s Loose
Before you buy anything, lock every double-hung window. The sash lock pulls the two sashes together at the middle and presses them against the frame. A window that’s closed but unlocked often leaks right at that meeting rail. If the lock doesn’t pull the sashes tight, the screws may be loose or the lock may need to be moved slightly. Also make sure the top sash is pushed all the way up. They slide down over the years, and that leaves a gap at the top you can’t see from the floor.
Step 3: Caulk the Gaps Around the Trim
Caulk is for gaps that don’t move: between the window trim and the wall inside, and between the window frame and the siding or brick outside. It is not for the moving parts of the window. If you caulk a sash shut, you’ve made a window you can’t open in a fire.
- Scrape out the old, cracked caulk with a putty knife or a stiff 5-in-1 tool.
- Clean and dry the joint. The DOE’s caulking guide says to make sure the area is dry so you don’t seal moisture in.
- Cut the tip at an angle, small at first. You can always cut it bigger.
- Run one steady bead, pulling the gun toward you.
- Smooth it every couple of feet with a damp finger or rag, and wipe mistakes right away. Dried caulk is much harder to clean up.
Use a paintable caulk inside so you can touch up the trim. Outside, use one rated for exterior use, and check the temperature range on the tube: many won’t go on well in a cold snap, so do the outside first on a milder day. DOE estimates about half a cartridge per window, and most caulk takes about a day to cure. More detail on technique is in how to caulk trim and baseboards.
Step 4: Weatherstrip the Sashes
Weatherstripping seals the parts that move. On a double-hung window:
- Sides of the sashes: V-strip (a folded vinyl or metal strip) in the side channels works well because the sash can still slide past it.
- Bottom of the lower sash: a compressible foam or rubber strip on the bottom edge seals against the sill when it’s closed.
- The meeting rail: if there’s still a gap after the lock is tight, a thin V-strip or foam strip on one rail closes it.
Casement windows (the crank-out kind) usually have a gasket around the sash. If it’s flattened, cracked or missing, replacement gaskets are often available from the window maker. Clean the surface well before applying any self-stick strip or it’ll peel off by January. If you’re new to it, what weatherstripping is and the types covers the basics.
Step 5: Temporary Fixes for Windows You Can’t Fix Yet
Some windows are just worn out: loose sashes, broken balances, single-pane glass. You can still make them a lot better for the winter.
Rope caulk. It’s a soft, putty-like strip you press into gaps by hand. It doesn’t harden, so it peels out in spring. It’s great for the meeting rail and the edges of a window you won’t open all winter. The DOE notes these quick-fix products usually last only a few seasons, so think of it as a winter fix, not a permanent one.
Shrink-film kits. Clear plastic film you tape to the inside trim and tighten with a hair dryer. It stops drafts from the whole window and adds a layer of still air. A few tips, mostly from the Frost King kit instructions:
- The tape goes on clean, dry, painted wood, metal or vinyl. Frost King says not to put it on wallpaper, drywall or plaster, because it can pull the surface off when you remove it.
- Shrink it with the dryer on high, held about 4 to 6 inches away, and keep the dryer from touching the plastic.
- Don’t over-shrink it. Too much tension pulls the tape loose.
- You can’t open the window until you take the film off, so skip it on any window you’d need as an exit.
Heavy curtains or cellular shades help too, especially at night. If you’re adding them, see how to measure for blinds and curtains.
Time, Cost and Difficulty
- Difficulty: easy. If you can run a bead of caulk, you can do this.
- Time: plan on roughly 20 to 45 minutes a window for caulk and weatherstripping, less for rope caulk. Shrink film goes fast once you’ve done one.
- Tools: caulk gun, putty knife, utility knife, rags, tape measure, scissors and a hair dryer for film.
Common Mistakes
- Caulking over old, cracked caulk. It won’t stick and it’ll crack again.
- Caulking a sash shut. Every bedroom needs a window that opens.
- Sealing the weep holes at the bottom of vinyl or storm windows. Those let water out. Leave them open.
- Skipping the lock. An unlocked double-hung window leaks no matter how much you seal.
- Blaming the window for a humidity problem. Water running down the inside of the glass is condensation from indoor moisture, not a leak. Sealing drafts can make it more noticeable, so keep an eye on humidity and run bath fans.
Safety: Old Paint on Old Windows
If your house was built before 1978, the paint on the window trim and sashes may contain lead. Windows are one of the worst spots, because sashes rubbing in their tracks make dust. Don’t dry-scrape, sand or heat-gun old paint to get a sash moving or clean up a joint. Test first or treat it as lead, mist the area, keep kids and pets away, and clean up with wet wipes and a HEPA vacuum. The EPA’s lead page explains the risks.
DIY or Call a Guy?
DIY it: finding drafts, tightening locks, caulking interior trim, adding V-strip or foam, rope caulk and shrink film. This is very doable, and you’ll feel the difference the same day.
Call a guy: when there are a lot of windows, when the outside caulking means working off a ladder on a second floor, or when there’s peeling paint that may be lead. Call a window pro if the sashes are rotted, the glass is cracked or fogged between panes, or the frames themselves are loose. Replacement or storm windows may be the better fix at that point.
Local to Euclid or Cleveland’s east side? I recaulk windows and trim and install weatherstripping myself. See my Caulking in Euclid & Cleveland page or my Handyman Time Blocks for a few windows and doors at once, or text me a photo at 216-800-5883.
FAQ
What’s the cheapest way to stop a drafty window?
Lock it, then press rope caulk into the gaps. It costs very little, goes on in minutes, and peels out in spring.
Should I caulk inside or outside?
Both, but for different jobs. Outside keeps out water and wind. Inside stops the air that gets behind the trim. Never caulk the moving parts of the sash.
Does window shrink film really help?
Yes, on loose or single-pane windows it stops drafts and adds a layer of still air. The trade-off is you can’t open that window until you take the film off.
Why is my window wet on the inside?
That’s condensation: indoor humidity hitting cold glass. It’s not a leak. Lower the humidity and use bath and kitchen fans.
When should I replace drafty windows instead?
When the sashes or frames are rotted, the glass is fogged between panes, or the window won’t stay up or lock even after adjusting. If they’re in good shape, DOE says improving your existing windows may be the most cost-effective option.
Related Guides
- How to check your home for drafts
- How to install weatherstripping on a door
- Storm windows and storm doors: are they still worth it?
- Thermostat settings for Ohio winters and summers
- How to prevent ice dams on your roof
- Improving your home’s energy efficiency with insulation
Sources
- U.S. Department of Energy, Energy Saver: Energy Efficient Windows
- U.S. Department of Energy: DIY Savings Project, Seal Air Leaks (Caulk)
- Frost King: Window Insulation Kit Instructions
- EPA: Protect Your Family from Sources of Lead

Scan to join our Loyalty Program, get a free coupon for your next service, and stay up to date on our services and articles.
Affiliate Note
Some of the links in this article are affiliate links. That simply means if you choose to buy through them, I may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. I only recommend products I trust and would feel comfortable installing in my own home or a client’s home.
If you try something I recommended and it turns out to be anything less than a five-star experience, please let me know. I always want these recommendations to be genuinely helpful.
