WinterizingNovember 22, 2026by Colin

Thermostat Settings for Ohio Winters and Summers

Short Answer

In winter, start around 68°F when you’re home and awake, then set it back 7 to 10 degrees while you sleep or are out. The U.S. Department of Energy says doing that for at least 8 hours a day can save as much as 10% a year on heating and cooling. In summer, 78°F while you’re home is the usual starting point, warmer when you’re gone. If you leave during cold weather, the Red Cross says to keep the heat no lower than 55°F. Heat pumps are the exception: keep setbacks small.

This box contains affiliate links. As an Amazon Associate I earn from qualifying purchases. See the affiliate note at the bottom of this post.

🛒 Helpful Picks

These are well-reviewed options, not my personal picks. Check that any thermostat works with your system before you buy (more on that below).

Most people set the thermostat once in October and fight with it until spring. A few simple settings, and knowing what kind of system you have, will keep the house comfortable and the gas bill lower through a Northeast Ohio winter and a muggy summer.

Winter Settings That Make Sense

These are starting points. Adjust a degree or two at a time until the house feels right.

  • Home and awake: about 68°F. The Department of Energy recommends starting at 68 to 70°F and going as low as you’re comfortable.
  • Asleep: 7 to 10 degrees lower. Around 58 to 61°F if you start at 68. Most people sleep fine cooler with an extra blanket.
  • Out for the day: the same setback. DOE says setting back 7 to 10°F for at least 8 hours a day can save as much as 10% a year.
  • Away for a few days or more: no lower than 55°F. That’s the Red Cross number for keeping pipes from freezing while you’re gone.

The exception: a hard cold snap. When it drops into the single digits, the Red Cross says to keep the thermostat at the same temperature day and night. If you have pipes on an outside wall, under a sink against an exterior wall, or in a crawlspace, skip the deep overnight setback until the cold breaks. A burst pipe costs a lot more than a few nights of heat.

Does Turning It Down Really Save Money?

Yes. The old idea that the furnace “works harder” to warm the house back up doesn’t hold for a typical gas furnace. A house loses heat faster when it’s warmer inside, so the hours it spends cooler are hours it’s losing less heat. The furnace runs to catch up in the morning, but it used less gas overnight than it would have holding 68 all night.

The trick is getting the timing right so you don’t wake up to a cold house. Program the heat to start coming back up about half an hour before you get up, and adjust from there.

Summer Settings

  • Home: about 78°F. That’s the common baseline for cooling. Ceiling fans let it feel cooler without touching the thermostat, but they cool people, not rooms, so turn them off when you leave. (Here’s which way your ceiling fan should spin in summer vs winter.)
  • Away or asleep: a few degrees warmer. The same idea as winter: the closer the inside is to the outside, the less the AC runs.
  • Humid days: Northeast Ohio summers are sticky. If the house feels clammy at 78, the problem is usually humidity, not temperature. Keeping windows closed on muggy days and running a dehumidifier in the basement helps more than dropping the setting.

Heat Pumps Are Different

If you have a heat pump, don’t use the big 10-degree setback. When a heat pump has to recover from a deep drop, the thermostat often brings on the backup heat (usually electric heat strips), which costs a lot more to run. Carrier recommends keeping a heat pump steady, or using small setbacks of 2 to 3 degrees. DOE’s Building America program says the same for variable-speed heat pumps: avoid deep setbacks.

A few heat pump tips:

  • Use a thermostat that’s made for heat pumps. A smart one with “adaptive” or “smart recovery” warms the house slowly with the heat pump instead of jumping to backup heat.
  • Don’t leave it on Emergency Heat. That setting runs only the backup heat. It’s for when the heat pump itself isn’t working.
  • If your system has a gas furnace as the backup (dual fuel), the settings get more involved. That’s a question for your HVAC tech.

Humidity in Winter

The EPA says to keep indoor humidity below 60%, ideally between 30% and 50%. In winter, the cold outside air makes the inside dry, so static shocks and dry skin are common. But too much humidity in a cold snap shows up as water dripping down the inside of your windows and mold on the sills.

  • A cheap humidity monitor tells you where you actually are instead of guessing.
  • If windows are sweating, you’re too high for how cold it is outside. Turn the humidifier down.
  • Run bath fans during and after showers. That’s where a lot of winter moisture comes from.

Leaving for Vacation

  • Set the heat no lower than 55°F (higher if you’ve had pipes freeze before).
  • Open cabinet doors under sinks on outside walls so warm air gets to the pipes.
  • Think about shutting off the main water valve. Here’s when it makes sense to turn off the main valve before a trip.
  • Have someone check the house if you’ll be gone more than a few days. A smart thermostat that sends a low-temperature alert to your phone is a good backup.
  • Pets at home with a sitter? Keep it at a temperature they’re comfortable in, not the bare minimum.

Programmable or Smart: What to Check Before You Buy

Either one saves money if you actually set a schedule. A smart thermostat is easier to adjust and some learn your routine. Before you buy, check:

  • Your system type. Gas furnace, heat pump, boiler, or electric baseboard. Most thermostats you see in stores are low-voltage (24-volt) units for furnaces and heat pumps.
  • Electric baseboard heat is different. Those use line-voltage thermostats (120 or 240 volts) and need a thermostat made for that. That’s real household voltage, so it’s electrician work if you’re not sure.
  • A C-wire. Many smart thermostats need a “common” wire for constant power. Take a photo of the wires behind your current thermostat and run it through the manufacturer’s compatibility checker.
  • Old mercury thermostats. Older round thermostats can have a small glass vial of mercury inside. Don’t throw one in the trash. Take it to your county’s household hazardous waste program or ask your HVAC company about recycling it.

Time and Difficulty

Changing settings or programming a schedule takes 15 to 30 minutes and is easy. Swapping a simple low-voltage thermostat on a gas furnace is a moderate DIY job, about an hour if the wiring matches. Heat pumps, multi-stage systems, and anything with missing or mystery wires can take a lot longer.

Common Mistakes

  • Cranking it to 80 to warm up faster. Most furnaces put out the same heat no matter what the setting is. It just overshoots and wastes gas.
  • A thermostat in the wrong spot. Direct sun, a drafty hallway, or a lamp right below it all throw off the reading.
  • Dead batteries. Many thermostats run on AA or AAA batteries. Change them every fall.
  • Leaving it on “Hold” after a one-time change and forgetting the schedule is off.
  • Running the fan on “On” all winter. “Auto” runs the blower only when it’s heating or cooling. “On” runs it all the time, which uses electricity and can make vents blow cool air between cycles.
  • Using deep setbacks with a heat pump.

Safety Notes

Turn off power to the furnace or air handler at the breaker or the furnace switch before you take a thermostat off the wall. Never work on a line-voltage thermostat with the power on. And heating season is CO season: make sure you have working carbon monoxide detectors in the right spots before the furnace runs every day.

DIY or Call a Guy?

DIY it: choosing settings, programming a schedule, changing batteries, and swapping a basic low-voltage thermostat on a gas furnace when the compatibility check says it matches.

Call a pro: an HVAC tech for heat pumps with backup heat, dual-fuel systems, boilers, multi-zone setups, or if the furnace can’t hold temperature, short-cycles, or blows cold air. An electrician for line-voltage baseboard thermostats if you’re not sure what you’re doing. Thermostats aren’t something I install.

Local to Euclid or Cleveland’s east side? I don’t install thermostats, but a lot of “I keep turning it up and it still feels cold” comes from drafts around doors and windows. I install weatherstripping and recaulk gaps myself. See my Handyman Time Blocks for doors and weatherstripping or my Caulking in Euclid & Cleveland page, or text me a photo at 216-800-5883.

📱 Text Colin a Photo

FAQ

What is a good thermostat setting for winter in Ohio?
Around 68°F when you’re home and awake, and 7 to 10 degrees lower while you sleep or are out. If you have a heat pump, keep the setback to 2 or 3 degrees.

Is it cheaper to leave the heat at one temperature all day?
Not with a typical gas furnace. DOE says a 7 to 10 degree setback for 8 hours a day can save as much as 10% a year. Heat pumps are the exception, because a big recovery can bring on expensive backup heat.

What’s the lowest I can set the heat when I’m away?
The Red Cross says no lower than 55°F during cold weather. Go higher if you’ve had a pipe freeze before or have plumbing on outside walls.

Should the fan be on Auto or On?
Auto, for most homes. It runs the blower only when the system is heating or cooling.

What humidity should my house be in winter?
The EPA recommends keeping it below 60%, ideally 30% to 50%. If your windows are sweating, turn it down.

Related Guides

Sources

QR code to join the Colin Can Help loyalty program

Scan to join our Loyalty Program, get a free coupon for your next service, and stay up to date on our services and articles.

Affiliate Note

Some of the links in this article are affiliate links. That simply means if you choose to buy through them, I may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. I only recommend products I trust and would feel comfortable installing in my own home or a client’s home.

If you try something I recommended and it turns out to be anything less than a five-star experience, please let me know. I always want these recommendations to be genuinely helpful.

Colin Can Help LLC, 2026 © All Rights Reserved