Short Answer
Yes, if you have older single-pane or leaky windows, or an old entry door that’s still solid. A good low-e storm window can cut heating and cooling costs by roughly 10% to 30% according to the U.S. Department of Energy, for a fraction of the cost of new windows. A storm door helps most on an older wood door. If your windows or entry door are newer and insulated, a storm unit usually isn’t worth the money.
This box contains affiliate links. As an Amazon Associate I earn from qualifying purchases. See the affiliate note at the bottom of this post.
🧰 What You’ll Need
What I Use:
For sealing the top and sides of a storm window opening and the drip cap and sides of a storm door frame. Never the bottom of a storm window, more on that below.
Check price →
For pilot holes when you screw a storm door frame or storm window flange into old wood trim. Pilot holes keep the screws straight and stop the trim from splitting.
Check price →
Helpful Picks: these are well-reviewed options, not my personal picks. Measure first and match sizes to your door or window.
What Storm Windows and Storm Doors Actually Do
A storm window or storm door is a second layer that sits outside (or inside) the window or door you already have. The air trapped between the two layers slows heat loss, and the extra layer blocks a lot of the drafts that sneak around old sashes and door edges.
They were standard on older homes for a reason. Before double-pane windows and insulated steel and fiberglass doors, a storm unit was the main way to make a house tolerable in a Cleveland winter. A lot of East Side homes still have the old aluminum triple-track storms from decades ago, some working fine, some barely hanging on.
The question isn’t whether they work. It’s whether they’re worth it on your house.
When Storm Windows Are Worth It
Storm windows make the most sense when:
- You have original single-pane wood windows that are still in decent shape. Adding a storm is usually far cheaper than replacing them, and you keep the original windows.
- Your windows are drafty but the frames aren’t rotted. A storm window covers a lot of the air leakage around old sashes.
- Replacement isn’t in the budget yet. The DOE says low-e storm windows can match the energy savings of full replacement at about one-third the cost.
The numbers from the DOE’s storm windows page: low-e storm windows can save 10% to 30% on heating and cooling costs depending on the window you already have, reflect radiant heat about 35% better than clear-glass storms, and can cut whole-house air leakage by 10% or more. Its DIY low-e storm window project estimates $60 to $200 per window and 20 to 30 minutes to install each one.
That “low-e” part matters. A modern low-e storm window is a different product from the plain-glass storms most older houses have. If you’re replacing worn-out storms anyway, look for low-e glass and an ENERGY STAR or AERC rating.
When Storm Windows Aren’t Worth It
- You already have decent double-pane windows. The gain is much smaller, and a storm can hurt how the window looks and works.
- The window itself is rotted or broken. Fix the window first. The DOE’s install guide says to repair missing glass, rotting wood, broken parts and leaks before a storm goes on.
- It’s a bedroom window you’d need to escape through. Don’t block an egress window with a fixed storm panel. Use an operable storm that opens easily from inside, or skip it on that window.
When a Storm Door Is Worth It
The DOE’s guidance on doors sums it up: a storm door can be a good investment if your existing door is old but still in good condition, and it’s generally not worth it on a newer insulated door.
Beyond energy, a storm door does a few practical things:
- Protects an older wood front door from rain, snow and lake-effect wind, so the paint and finish last longer.
- Adds a screen so you can let air in during spring and fall without the bugs.
- Cuts the draft at doors where the weatherstripping can only do so much.
Look for a full-view door with interchangeable glass and screen panels, or a self-storing screen that slides up out of the way. Metal-framed doors with foam inside the frame are sturdier than the thin ones.
The sunlight problem
Here’s the one people miss. A glass storm door on a door that gets direct afternoon sun can trap a lot of heat between the two doors. The DOE warns this can damage the entry door. Check your entry door’s manufacturer recommendations before you add a full-glass storm on a sunny side, and choose low-e glass if you go ahead.
Ventilation and Condensation
Storm windows trap air, which is the point. They can also trap moisture if things aren’t set up right.
- Weep holes: exterior storm windows should have small weep holes or slots at the bottom of the frame so water and moisture can get out. Keep them clear of paint, caulk and dirt.
- Don’t caulk the bottom: caulk the top and sides of an exterior storm window, never the bottom. That’s where water needs to escape.
- Fog between the window and the storm usually means warm, moist indoor air is leaking past the inside window. Tighten that one up with weatherstripping or caulk. The inside window should be the tighter of the two.
- Operable storms let you open the window for fresh air in spring and fall. Fixed panels don’t.
How Installation Works
Exterior storm windows
- Measure the opening width at the top, middle and bottom between the inside edges of the casing, and the height from the top of the casing to the highest point of the sill. Round down to the nearest 1/8 inch and order using the smallest width.
- Dry-fit the storm, check which end is up, and make sure the screw holes will land in solid wood.
- Pull it out, then run a bead of caulk along the top and sides of the opening. Skip the bottom.
- Set it back in, push the top snug, and drive the top corner screws.
- Tap the bottom expander down so it sits evenly on the sill.
- Square it up with an even gap on each side and drive the rest of the screws.
Those steps follow the DOE’s DIY guide. On a ground-floor window it’s a reasonable DIY job. Second-floor windows mean ladder work with a bulky piece of glass in your hands, which is where a lot of people decide to hire it out.
Storm doors
- Measure the opening between the brick molding (the exterior trim around the door) at the top, middle and bottom, and the height from the threshold to the top of the opening.
- Decide which side you want the hinges on. Most people hinge it on the same side as the entry door, but check that the handle and closer won’t fight a railing or light fixture.
- Install the drip cap at the top, then the hinge-side frame piece (often called a Z-bar), plumb and level.
- Hang the door, then add the latch-side frame and adjust the bottom expander so the sweep seals against the threshold.
- Install the handle, latch, closer and wind chain, then adjust the closer so the door shuts fully without slamming.
Older East Side houses rarely have perfectly square openings, so plan on shimming and adjusting. If you’ve never hung a door, expect most of a day for your first storm door.
Northeast Ohio Notes
- Wind: lake-effect gusts can catch a storm door and bend the hinges or rip the closer bracket out. Use the wind chain, and replace a weak closer before it fails.
- Cold-weather installs: caulk doesn’t love freezing temperatures. Do storm window and door installs on a milder day if you can, or use a caulk rated for low temperatures.
- Old storms: on older homes, check the existing aluminum storms before replacing them. Sometimes all they need is a new sash, a cleaned-out track, fresh caulk at the top and sides, and clear weep holes.
- Older homes and paint: if your house was built before 1978, old trim and window frames may have lead paint. Don’t dry-sand or scrape them while you’re prepping for a storm unit.
Common Mistakes
- Caulking the bottom of a storm window and trapping water against the sill.
- Painting over or caulking the weep holes.
- Putting a storm door over a newer insulated door and expecting a big energy difference.
- Adding a full-glass storm door on a sunny door without checking the entry door’s manufacturer recommendations.
- Ordering from one measurement instead of measuring the top, middle and bottom.
- Covering a leaky inside window with a storm and ignoring it, then dealing with fog and moisture between the two.
DIY or Call a Guy?
DIY it if you’re adding storm windows to ground-floor windows with solid wood around them, or replacing a storm door closer, sweep or wind chain. These are manageable with a drill, a tape measure and some patience.
Call someone if it’s second-story windows, the frames or brick molding are rotted, the opening is badly out of square, or you’d rather not wrestle a full storm door into place on your own. Rot and water damage around the frame should be fixed before anything gets hung on it. If you’re still sorting out where the cold air is coming from, start with my guide on how to check your home for drafts, and for door edges, how to install weatherstripping on a door may solve it for a lot less. My post on repairing and refreshing your front door covers what’s worth fixing on the door itself.
Local to Euclid or Cleveland’s east side? I install and adjust storm doors myself. See my Handyman Time Blocks in Euclid & Cleveland page, or text me a photo at 216-800-5883.
FAQ
Do storm windows really save money?
On older single-pane windows, yes. The DOE puts low-e storm window savings at 10% to 30% on heating and cooling costs, depending on the windows you already have. On newer double-pane windows, the savings are much smaller.
Are interior or exterior storm windows better?
The DOE says rated interior and exterior storm windows can produce similar savings. Exterior storms also protect the window from weather. Interior ones are easier to install and remove, and are often the choice when you don’t want to change how the outside of the house looks.
Should I take my storm door glass out in summer?
If it gets direct sun, swapping to the screen panel in warm months helps keep heat from building up against your entry door.
Why is there fog between my window and the storm window?
Usually warm, moist indoor air is getting past the inside window. Seal the inside window better and make sure the storm’s weep holes are clear.
Is a storm door worth it on a newer front door?
Usually not for energy. The DOE says it’s generally not worth it on a newer insulated door. Some people still want one for the screen or to protect the door from weather.

Scan to join our Loyalty Program, get a free coupon for your next service, and stay up to date on our services and articles.
Affiliate Note
Some of the links in this article are affiliate links. That simply means if you choose to buy through them, I may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. I only recommend products I trust and would feel comfortable installing in my own home or a client’s home.
If you try something I recommended and it turns out to be anything less than a five-star experience, please let me know. I always want these recommendations to be genuinely helpful.
