Short Answer
If it’s one small piece (a nightstand, a bookcase, a TV stand) and you have a free afternoon, build it yourself. It’s worth hiring someone when you’ve got several pieces at once, a big item like a bed frame, wardrobe or crib, anything tall that needs to be anchored to the wall, or a deadline like a move-in date or a nursery. The real cost of doing it yourself is time, a sore back and the occasional piece that never sits quite right.
This box contains affiliate links. As an Amazon Associate I earn from qualifying purchases. See the affiliate note at the bottom of this post.
🧰 What I Use
What comes out of my bag on an assembly job, besides the little hex key in the box:
- My 2-foot level, to check that dressers and shelving sit flat before anything gets anchored
- My stud finder, for the anti-tip strap on anything tall
- My drill bit set, for clean pilot holes into studs and the back panel
🛒 Helpful Picks
These are well-reviewed options, not my personal picks.
- A basic cordless drill/driver with an adjustable clutch (you don’t need an expensive one; the clutch is what matters)
- A hex (Allen) bit set that fits a drill or screwdriver handle
- A furniture anti-tip kit, in case yours didn’t come with one or the screws don’t suit your walls
- A rubber mallet for seating dowels and drawer bottoms without denting anything
Flat-pack furniture is built so anyone can put it together, and most people can. The question isn’t really “can I?” It’s whether it’s worth your evening, your back, and the risk of a dresser that wobbles for the next ten years. Here’s how I’d think about it, piece by piece.
What Actually Makes Assembly Hard
It’s rarely the instructions. Most of the trouble comes from:
- Size and weight. Wardrobes, tall bookcases, bunk beds and big desks are a two-person job. Standing a tall unit up by yourself is how backs, walls and the furniture get hurt.
- Volume. One nightstand is fun. A whole bedroom set, or an office with a desk, chair, file cabinet and two shelves, is a weekend.
- Getting it square. If the frame isn’t square before the back panel goes on, drawers rub and doors never line up.
- Particleboard. Much flat-pack furniture is particleboard, which strips easily. One overtightened screw and that hole never holds the same again.
- Anchoring. Tall pieces need to be strapped to the wall, and that means finding a stud or using the right anchor for your wall. That’s where a lot of people stop.
When Doing It Yourself Makes Sense
- It’s a small or medium piece: a nightstand, side table, TV stand, short bookcase, simple desk or chair.
- You’ve got a clear floor, a couple of free hours, and nobody waiting on it.
- You have a second person for anything big.
- It’s short enough that tipping isn’t a concern, or you’re comfortable finding a stud and anchoring it.
When It’s Worth Hiring Someone
- Multiple pieces at once, like a move-in, a new home office, or a bedroom set.
- Big or heavy items: bed frames with storage drawers, wardrobes and armoires, bunk and loft beds, large sectionals, gym equipment.
- Anything a child will use or climb near: cribs, kids’ dressers, bunk beds. These need to be right, not almost right.
- Tall pieces that need anchoring into plaster, brick, or a wall where you can’t find a stud.
- A deadline. A nursery before the due date, a rental before the tenant moves in, guests coming Friday.
- You’ve already started and something doesn’t line up. It’s easier to fix early than after the back panel is nailed on.
How Long Does It Take?
Every piece is different, so treat these as rough ranges for one person working carefully: a nightstand or small bookcase is often an hour or so, a desk or TV stand an hour or two, a dresser or bed frame a couple of hours or more, and a big wardrobe or loft bed can eat most of a day. Expect your first piece from a new brand to take longer than the box suggests. Unpacking, sorting hardware and breaking down cardboard adds more time than people plan for.
Tips If You’re Doing It Yourself
- Read the whole manual first. Look for the steps where a panel faces a certain way. Those are the ones that get done backward.
- Sort and count the hardware before you start. Put each letter in its own cup or muffin tin. If something’s missing, you want to know now, not at step 23.
- Build on the cardboard, not a bare hardwood floor. It protects the floor and the finish.
- Snug, don’t crank. If you use a drill, set the clutch low and finish by hand. Stripped particleboard is the number one thing I see go wrong.
- Square it before the back goes on. Measure corner to corner both ways. When the two numbers match, it’s square.
- Get help for the lift. Two people to stand up anything taller than you.
- Anchor it before you load it. Drawers full of clothes make a dresser heavier, but they don’t make it safer if a kid pulls the drawers open and climbs.
- Save the manual and extra hardware in a zip bag taped inside the piece. You’ll want them when you move.
Warranty and Instructions
Keep the box label or receipt and the manual. If a part arrives cracked or something’s missing, most retailers want you to contact them before you modify the piece. Check the warranty terms for your specific item, and follow the manufacturer’s instructions, especially for cribs and anything that holds weight overhead. Don’t drill extra holes or swap hardware on a crib.
Safety: Tall Furniture Tips Over
This is the part I don’t skip. The U.S. Consumer Product Safety Commission says it knows of 234 deaths from dresser and clothing storage tip-overs from 2000 through April 2022, 199 of them children. A federal stability standard for dressers and similar furniture took effect in September 2023, and the CPSC still recommends anchoring furniture securely to the wall. The Anchor It campaign has more on why.
Use the tip restraint that came in the box when it suits your wall, and screw it into a stud when you can. If it doesn’t suit your wall (plaster, brick, no stud where you need it), get hardware that does. I walk through it step by step in how to anchor furniture and TVs to prevent tip-overs. Not sure what’s behind your wall? Here’s how to tell plaster from drywall.
Common Mistakes
- Overtightening screws into particleboard until they spin.
- Installing a panel with the finished side facing in, or the pre-drilled holes on the wrong side.
- Skipping the cam locks or tightening them only halfway.
- Nailing the back panel on before the frame is square.
- Throwing out the “extra” hardware that turns out to be the anti-tip kit.
- Leaving a tall dresser or bookcase unanchored “for now.”
DIY or Call a Guy?
DIY it if it’s one or two smaller pieces, you’ve got the time, and nothing needs to go into the wall.
Call someone if you’ve got a pile of boxes, a big or heavy piece, a crib or bunk bed, anything tall that needs anchoring, or a date it has to be done by. If you’re also hanging shelves, curtains or pictures in the same room, it’s worth bundling it all into one visit. Here’s a look at what a handyman can actually fix while they’re there. New curtains going up too? Start with how to measure for blinds and curtains.
Local to Euclid or Cleveland’s east side? I assemble furniture myself, and I anchor the tall pieces while I’m there. See my Furniture Assembly in Euclid & Cleveland page, or text me a photo of the boxes at 216-800-5883. If you’ve got a list of other small jobs too, my Handyman Time Blocks page explains how booking a block of time works.
FAQ
Is it worth paying someone to assemble IKEA or Wayfair furniture?
For one small piece, usually not. For a room full of furniture, a big wardrobe or bed, a crib, or anything that needs to be anchored, it often is, because the time and the risk of a wobbly or stripped piece add up.
Do I need special tools to assemble furniture?
Most pieces come with a hex key and maybe a small wrench. A Phillips screwdriver, a rubber mallet and a cordless drill with a clutch make it faster. Use the drill on a low clutch setting and finish by hand.
Can one person assemble a dresser or wardrobe?
One person can usually build it while it’s lying down, but standing a tall piece up and moving it into place should be a two-person job.
Do I really need to anchor a dresser to the wall?
Yes, especially with kids in the house. The CPSC recommends anchoring furniture securely to the wall, even dressers built to the newer stability standard.
What should I tell a handyman before they come?
What the pieces are (brand and model if you have them), how many boxes, which room and floor they go on, and whether anything needs to be anchored. A photo of the boxes helps a lot.
Affiliate Note
Some of the links in this article are affiliate links. That simply means if you choose to buy through them, I may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. I only recommend products I trust and would feel comfortable installing in my own home or a client’s home.
If you try something I recommended and it turns out to be anything less than a five-star experience, please let me know. I always want these recommendations to be genuinely helpful.

