Rental Turnover Checklist: Everything to Check Between Tenants

Short Answer

Between tenants, walk the whole unit once and write everything down before you fix anything. Then work in this order: safety items (smoke and CO alarms, locks, railings, outlets), water (leaks, toilets, caulk), doors and windows, walls and paint, and cleaning and photos last. Most of a turnover is small stuff, but the small stuff is what the next tenant notices on day one and calls you about in week two.

This box contains affiliate links. As an Amazon Associate I earn from qualifying purchases. See the affiliate note at the bottom of this post.

🧰 What I Use

What I bring to every turnover walk-through:

🛒 Helpful Picks

These are well-reviewed options, not my personal picks.

A tenant moves out, and the clock starts. Every empty week costs rent, so it’s tempting to just paint, clean and hand over the keys. The problem is that the things a quick turnover misses (a toilet that runs at night, a smoke alarm that expired two years ago, a door that won’t latch) turn into service calls a month later, with someone living there. Here’s the checklist I’d work through, room by room, in the order that keeps you from doing anything twice.

Step 1: Walk It and Write It Down First

Before you fix a single thing, walk the whole unit with a notepad or your phone. Turn on every light, run every faucet, flush every toilet, open every door and window. Write down everything. A list lets you buy parts in one trip and decide what you’ll do yourself and what to hand off.

Take photos as you go: every room from the doorway, plus close-ups of any damage. Date-stamped photos of the unit as the last tenant left it, and again once it’s ready for the next one, are the simplest record you can keep. Save them in one folder per unit and per turnover so you can find them later.

Step 2: Safety Items

These come first because they matter most and they’re the easiest to forget when the unit looks clean.

  • Smoke alarms. Press the test button on every one. Then check the date printed on the back. The U.S. Fire Administration says to replace smoke alarms 10 years from the manufacture date and to have them in every bedroom, outside each sleeping area and on every level, including the basement. Here’s more on whether 10-year detectors are worth it for a rental.
  • CO alarms. Test them and check the date. CO alarms wear out too, and the replacement interval is on the label. A unit with a gas furnace, gas water heater or attached garage should have them; see where CO detectors should go.
  • Locks. Change or rekey the entry locks between tenants. You don’t know how many copies of the old key are out there. Test every deadbolt from inside and out, and make sure each door latches without being shoved.
  • Railings and handrails. Grab every stair rail and porch railing and pull on it. Loose ones get tightened or fixed before anyone moves in.
  • Outlets and switches. Make sure every switch does something and every outlet works. Press TEST and RESET on each GFCI outlet in the kitchen, bathrooms, basement and outside. Look for cracked cover plates, scorch marks or anything warm. Anything that looks burned is a job for an electrician, not a cover-plate swap.

Step 3: Water and Plumbing

Water problems hide, and tenants often don’t report the slow ones.

  • Under every sink. Wrap a dry paper towel around each shut-off valve, supply line and drain joint, run the water for a couple of minutes, then check for damp spots. Look at the cabinet floor for swelling or stains.
  • Shut-off valves. Turn each one off and back on. Old valves sometimes won’t close, or start dripping once moved, and you’d rather find that out now.
  • Toilets. Rock each one gently. It shouldn’t move. Put a few drops of food coloring in the tank and wait 15 minutes without flushing; color in the bowl means a leaky flapper.
  • Faucets and showerheads. Check for drips, low pressure and loose handles. Here’s how to stop faucet leaks.
  • Caulk. Look at the tub, shower, sink and backsplash. Cracked, moldy or peeling caulk comes out and gets redone. It’s cheap now and expensive later, once water gets behind it.
  • Water heater and furnace. Look for rust, puddles or a musty smell around them, and note the furnace filter. If you see a leak or anything you’re not sure about, call a plumber or HVAC tech.

The bathroom deserves its own list. I wrote one: the rental bathroom turnover checklist goes fixture by fixture.

Step 4: Doors, Windows and Hardware

  • Interior doors: they should open, close and latch without rubbing. A loose hinge screw is often the culprit.
  • Closet doors: bifolds and sliders come off their tracks constantly in rentals. Here’s how to fix sliding closet doors.
  • Exterior doors: check the weatherstripping and the door sweep. If you can see daylight around a closed door, the next tenant will feel it in January. See how to install door weatherstripping.
  • Screens, blinds and hardware: replace torn screens and broken slats, and tighten loose towel bars and cabinet pulls.

Step 5: Walls, Trim and Paint

Do this after the repairs, so you’re not touching up paint you just scuffed with a ladder.

  • Fill nail holes and anchor holes. Patch bigger damage (door handle holes, gouges) properly instead of just painting over it.
  • Recaulk gaps at baseboards and trim where it’s cracked. Here’s how to caulk trim and baseboards.
  • Decide between touch-ups and a full repaint. Touch-ups only blend when the paint is the same color and sheen and hasn’t faded much. If you’ve got a mix of patched spots and flashing, a full coat on that wall usually looks better and takes less time than chasing spots.
  • Write down the paint color, brand and sheen for every room and keep it with the unit’s photos. Next turnover, touch-ups get a lot easier. I’ve covered the best paint for rental properties separately.

One rule I stick to: plastic drop cloth down first, with a fabric one on top. I started doing that after paint soaked through a fabric cloth and stained a customer’s carpet.

Step 6: Kitchen and Appliances

Run every burner, the oven, the dishwasher, the range hood and the fridge, and clean behind the fridge and stove if you can pull them out. If there’s a dryer hookup, look at the vent hose: a crushed or lint-packed hose gets dealt with before the next tenant runs a load.

Step 7: Outside, Cleaning and Final Photos

  • Clear anything the last tenant left in the yard, garage or basement.
  • Check that gutters and downspouts are clear and pointed away from the foundation, especially heading into winter.
  • Clean last, top to bottom: fans and fixtures, window tracks, then floors.
  • Take your “ready” photos of every room, from the same spots as the walk-through photos, and test the alarms one more time on your way out.

Time and Difficulty

  • Time: the walk-through takes about an hour for an average apartment or small house. After that it depends on the list: a well-kept unit might be a day or two of small repairs, touch-ups and cleaning, while a full repaint, heavy patching or a cleanout can stretch it to a week or more.
  • Difficulty: most of the list is easy, basic tools and patience. Rekeying, toilet internals and recaulking are moderate. Anything electrical beyond swapping a cover plate or a standard device, and anything gas-related, belongs with a licensed pro.

Common Mistakes

  • Painting first, then fixing doors and fixtures and scuffing the fresh paint.
  • Assuming the smoke alarms are fine because they didn’t chirp.
  • Skipping the lock change to save a few dollars.

Safety

  • Older buildings: if the unit was built before 1978, assume there may be lead paint under the newer coats. Don’t dry-scrape or sand old paint. The EPA has a page for property managers on lead-safe repair and painting that’s worth reading before any work that disturbs paint.
  • Electrical: turn off the breaker before you change a switch, outlet or fixture, and confirm it’s dead with a tester.
  • Gas: if you smell gas, leave and call the gas company. Don’t troubleshoot it yourself.
  • Local requirements: check with your city about anything it requires for rentals before the new tenant moves in.

DIY or Call a Guy?

DIY it if you live nearby, the unit was well kept, and the list is mostly filling holes, touching up paint, testing alarms and cleaning. A free weekend and a good list will get you there.

Call someone if the list is long, you live far away, you have more than one unit turning over at once, or every week of vacancy hurts. One person handling repairs, paint and haul-away in one trip is often faster than juggling three trades. If the last tenant left a lot behind, start with the junk; here’s where to start a cleanout.

Local to Euclid or Cleveland’s east side? I do rental turnovers myself: repairs, caulk, detectors, locks, paint and junk removal, and I can work through the whole list in one visit. See my Handyman Services for Landlords in Euclid & Cleveland page, or text me a photo at 216-800-5883. Got a long list and want it priced out first? I also do Repair List Estimate visits with a written, itemized estimate.

📱 Text Colin a Photo

FAQ

What should I check first between tenants?
Safety items: test every smoke and CO alarm and check its date, change or rekey the locks, and pull on every railing. Then check for water leaks.

Should I change the locks between tenants?
I would, every time. Rekeying keeps the same hardware and just changes the key, so it’s usually cheaper than new locks.

How often should smoke alarms be replaced in a rental?
The U.S. Fire Administration says 10 years from the manufacture date, which is printed on the back. Test them at every turnover, whatever their age.

Do I need to repaint the whole unit every time?
No. If the walls are the same color and sheen and in decent shape, touch-ups are fine. Repaint walls where patches and touch-ups would show.

Sources

QR code to join the Colin Can Help loyalty program

Scan to join our Loyalty Program, get a free coupon for your next service, and stay up to date on our services and articles.

Affiliate Note

Some of the links in this article are affiliate links. That simply means if you choose to buy through them, I may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. I only recommend products I trust and would feel comfortable installing in my own home or a client’s home.

If you try something I recommended and it turns out to be anything less than a five-star experience, please let me know. I always want these recommendations to be genuinely helpful.

Colin Can Help LLC, 2026 © All Rights Reserved